Read and save both eeprom and flash. Once eeprom has been read , press edit If you have a working key , put it in the hextage and press decrypt. It will now decode the correct ISN. Select the key slot you wish to add a key. Now press set.
☆☆Note , you may have to update the software in the gateway and body first. If so , see further down pdf on how to. Take a photo of the fuse locations. You will need when putting back. Remove fuses …
Autohex can extract the ISN from the engine ecu on the bench. SIEMEMS VDO 7841 364 DME MS S60 5WK9586
BMW X5 6WB instrument cluster retrofit. Matched vin and set km to zero. Add 6wb to vo using Autohex.
Coded and programmed and set up steering angle sensor using the Autohex HW4. Programmed the module and then reset the calibration.
Used Autohex to code and program brand new FEM supplied by BMW. Other tools did not support the software version as the software was too new and was the latest factory level. Autohex detected the software and downloaded it from the server. Coded afterwards and tested everything.
Fit programmed and coded new instrument cluster as the old one had been damaged by jump starting. The Autohex determined the correct software and downloaded from the server .
Got a F30 with stepper motor issues for the adaptive lights. Used Autohex to remove the adaptive lights in the vehicle order , then coded FEM body.
Extracted ISN from a second hand engine ecu. MSD80 on the bench using the Autohex. Simply wire up cas and dme and read ISN from the DME and write it back to the cas. It would be a good idea to update the DME software to have the latest version, it will also correct the…
Got a new F30 for light coding as a new frontright was fitted. Autohex detected the latest software online and programmed the FLE software. After coding the light was fully functional.